Selex Trimboard - Selex
Home CMPC Maderas Home Qualimad Home Selex

Selex Trimboard

Great dimensional stability and high physical-mechanical resistance. The board has one solid face, free of open defects favoring the application of moldaje substrates for construction. Due to its fenolformaldehyde-based manufacturing, it offers great moisture resistance which improves its reutilization capacity and useful life.

Selex Trimboard Uses


techumbres_cd

SELEX Trimboard
Uses: Detalle Tapacan


revestimiento_camiones_cd

SELEX Trimboard
Uses: Detalle Tapacan


pared_ranurada_sb

SELEX Beaded
Uses: Detalle Tapacan

DIMENSIONS
dimension_trim_1
Specialty – T&G
dimension_trim_2

GENERAL SPECIFICATIONS
Primed

  • In factory applied water based 100% acrylic primer.
  • Broad range compatibility with arquitectural solvent based oil and water based products.
  • Continuous quality control system ensures:
  • • The optimus thickness non-destructive measurement conforms to ASTM D6132 Standard.
    • Adecuate adhesion to the wood based on ASTM D 3359 & ASTM D 4541 standars.

  • Gloss: Over 3 units of matte shine at a 60 degree angle based on ASTM D523.
  • Primer coating thickness: Thick and even coating due to our state of-the-art vacuum priming system that{s applies two coats of water based 100% acrylic primer followed by buffing after each coat.

Glued

  • Exterior grade cross-linking PVA (Polyvinyl Acetate), non-structural adhesive.
  • High performace adhesive with outstanding results on porous substrates.
  • IFT osenhiem (Germany) certified to pass durability class D4 according to DIN EN 204 “evaluation of non-structural adhesives for joining wood and derived timber products”.
  • Adhesive tested by CanadaWood using method JIS A 1460 “Building Boards, Determination of Formaldehyde Emission – Dessicator Method” yielded emission test results of 0.10 mg/L, well below the level allowable to be classified for F **** use “without restriction”.
TECHNICAL INFORMATION
Weight:

  • Density: 450 Kg/m3
  • Weight per unit: 900 Kg

Defect free clear fiber.
Primer Adhesion

  • Pull-off strength greater than 13 Kgf/cm2 based on ASTM D4541 standard.
    • Fire Resistance

      • Carbonization Rate: 7 mm/min
      • Resistive properties are maintained given that internal temperature is kept low.

      Mechanical Properties:
      technical_1
      Based on the standard ASTM 198: Standard Test Methods of Static Tests of Lumber in Structural Sizes.

STORAGE AND HANDLING Cp/D

This product MUST be stored in a dry, clean location at all times and transported only if fully protected from water. Further until the final top-coat has been applied (after priming) and product has been installed (in conformance with all paint manufacturer recommendations as well as Highest and Best Building Practices, respectively, for intended use) it must be continuously protected from exposure to direct sunlight, ground contact, and adverse weather conditions. PRIOR to installation: (a) indoors, the product must be “acclimated” to the environment by storing it in the installation space for at least 3 days (with both faces exposed to the air in that space); (b) outdoors, any surface lacking both primer and top-coat must be properly coated to achieve protection. Please follow recommendations by paint manufacturer with regards to intended use.
Failure to conform strictly to these instructions will void any liability on the part of the manufacturer, subject to applicable laws.

CERTIFICATIONS